Adjusting Convertible Top Lock

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

If the installation position was not marked during removal, the convertible top lock must be adjusted using the following method.

Position convertible top lock.

Fig 1: Positioning Convertible Top Lock
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 1.1. Fit convertible top lock on the roof frame.
2. 1.2. Fit new fastening screws.
3. 1.3. Slide convertible top lock back completely. -arrow-
Tighten fastening screws to initial tightening torque → Initial tightening: 6 Nm (4.5 ftlb.)

Fig 2: Identifying Convertible Top Lock
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Close the convertible top completely using the switch in the vehicle.
Move convertible top to service position. → 6101IN CONVERTIBLE-TOP SERVICE POSITION .
Mark the position of the lock. -arrows-

Fig 3: Positioning Lock Mark
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Loosen fastening screws.
Move convertible top lock by -dimension X- away from direction of travel. → Adjustment value: 1.5 mm

Fig 4: Identifying Convertible Top Lock Dimension
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tighten fastening screws to the specified tightening torque. Tightening torque 36 Nm (27 ftlb.)