Installing Pressure Pipe

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Install pressure pipe.
1. 1.1. Insert pressure pipe.
2. 1.2. Position and tighten outer screw-type clamps.
  Tightening torque 5.5 Nm (4 ftlb.)
  
  Fig 1: Locating Pressure Pipe (Lower Part)
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit pressure pipe with rubber shroud for the throttle housing.
1. 2.1. Fit cable plug -3- , vacuum line -4- , vacuum hoses -5 and 6- and clamps -arrows- .
2. 2.2. Position screw-type clamp on rubber shroud for the throttle housing and tighten it.
  Tightening torque 5.5 Nm (4 ftlb.)
  
  Fig 2: Locating Pressure Pipe Clamps (Upper Part)
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.