Removing Clutch Pedal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Clutch Pedal Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

WARNING: Preloaded or pressurized components

Risk of squashing or bruising

→ Do not reach into the danger area.

→ Relieve the tension on components before starting work.

→ Secure components to prevent them from loosening suddenly.

Secure the clutch power spring assembly.
1. 1.1. Pull off rubber sleeve on the plenum panel -arrow- .
  
  Fig 2: Pulling Off Rubber Sleeve
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. 1.2. Press the clutch pedal -1- slightly -arrow A- until the clutch power spring axle -2- is visible through the bore.
  
  Fig 3: Securing Clutch Power Spring Assembly
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. 1.3. Guide a suitable cotter pin -3- into the bore on the clutch power spring axle -2- (-arrow B- ).
Loosen clutch master cylinder.

Fig 4: Disengaging Push Rod
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 2.1. Release retaining clip for push rod -1- in the clutch pedal -2- using a pliers T10005 (-arrows A- ) and pull it out -arrow B- .
2. 2.2. Turn the clutch master cylinder anti-clockwise by approx. 60° -arrow A- .
  
  Fig 5: Loosening Clutch Master Cylinder
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. 2.3. Pull the clutch master cylinder out slightly -arrow B- .
Remove pedal shaft.
1. 3.1. Remove securing clip -1- on the pedal shaft -2- using a screwdriver -arrow A- .
  
  Fig 6: Removing Pedal Shaft
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. 3.2. Press pedal shaft -2- through to the left -arrow B- and remove it.
Remove clutch pedal.

Fig 7: Removing Clutch Pedal
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
1. 4.1. Pull the clutch pedal -1- down slightly -arrow A- until the clutch power spring assembly -2- disengages.
2. 4.2. Turn the clutch pedal -1- and clutch power spring assembly -2- (-arrow B- ) and remove it from the pedal console.