WM 2X00IN Important Information On Adapting The DME Control Unit (Except CARRERA "Edition", CARRERA Cabriolet "Edition", CARRERA 4 "Edition", TARGA 4, TARGA 4S, TARGA 4 GTS, CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, CARR. 4 GTS CABRIO, CARRERA 4 Cabriolet "Edition"): Information
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Information
- Adaptation values are deleted or stored in EEPROM when ignition is switched off after control unit run-on has ended.
This depends on the run-on period of the engine compartment purge fan.
The run-on period of the engine compartment purge fan AFTER ignition is switched off depends on the engine compartment temperature.
The run-on period is as follows at the following engine compartment temperatures:
- < 45 °C: approx. 50 seconds
- 45... 70 °C: approx. 200 seconds
- > 70 °C: up to 20 minutes
- The following adaptations will be deleted automatically when you erase the fault memory (see information under 1)):
- Mixture adaptation
- Lambda adaptation
- Camshaft adaptation
- Knock adaptation
- Map-controlled thermostat adaptation