Intake Manifold Pressure Sensor Adaptation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Necessary after:

Replacing intake manifold pressure sensor

How?

PIWIS Tester:
1. 1.1. Meet preconditions:
  1. 1.1.1. Engine off.
  2. 1.1.2. Ignition on.
  3. 1.1.3. Engine cold.
2. 1.2. Select menu:
  1. 1.2.1. DME
  2. 1.2.2. Maintenance/repairs
  3. 1.2.3. Delete adaptation values
3. 1.3. Press [F12] to continue.
  1. 1.3.1. Information on deleting adaptation values
4. 1.4. Press [F8] to confirm.
  1. 1.4.1. Submenu of adaptation ranges
5. 1.5. Select adaptation range and press [F12] to continue.
  Information
  1. Adaptation values are deleted or stored in EEPROM when ignition is switched off after control unit run-on has ended.
  This depends on the run-on period of the engine compartment purge fan.
  
  The run-on period of the engine compartment purge fan AFTER ignition is switched off depends on the engine compartment temperature.
  
  The run-on period is as follows at the following engine compartment temperatures:
  - < 45 °C: approx. 50 seconds
  - 45... 70 °C: approx. 200 seconds
  - > 70 °C: up to 20 minutes
6. 1.6. Switch off ignition.
7. 1.7. Adapt throttle valve (see below).