Installing Rear Bumper
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Heat protection panels not fitted correctly
- Risk of damage to adjacent parts
→ Make sure the heat protection panels overlap correctly.
→ Replace damaged or deformed heat protection panels.
→ Check heat protection panels for deformation, secure fixing of the aluminum braided cord, cracks and missing or damaged fixing tabs.
→ At least 80% of the total sealing area must be sealed without gaps.
Installation is performed in reverse order to removal.
- Fastening screws for bumper. Tightening torque 23 Nm (17 ft. lbs.) +/-2 Nm (+/-1.5 ft. lbs.)
- Fastening screws for heat protection. Tightening torque 3 Nm (2 ft. lbs.)