Component Overview

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Overview Of Flywheel And Clutch

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Dual-mass flywheel (DMF)
Multiple-tooth screw, M10 x 29 (micro-self-locking) - always replace screws
Clutch plate
Clutch pressure plate
External Torx screw, M8

Counter-hold tool WE 1487 -1- must be screwed to the engine flange in order to counter it.
1. 1.1. To do this, secure the tool through the lower left bore in the flange using a screw and M10 nut -2- .
  
  Fig 2: Identifying Flywheel Counter-Hold Tool
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  NOTE:
  Removing and installing flywheel
  - Leaks
  - Risk of damage to the flywheel and adjacent components
  → Be very careful during removal and installation.
  
  → Get another person to help because of the weight.
Loosen and unscrew ten (multiple-tooth, micro-self-locking) fastening screws (M10 x 29) on the flywheel. Carefully remove the flywheel.
1. 2.1. Replace fastening screws.
  Information
  
  Check the friction surface of the flywheel. The flywheel must be replaced if it is damaged or discolored.
Visually inspect the friction surface on the flywheel.