Removing Front Fabric Lining

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Fabric Lining Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Pull top connection seal -1- out of the plastic cover -2- in -direction of arrow- .

Fig 2: Removing Top Connection
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew fastening screw -1- on the plastic cover -2- . Lift the plastic cover up slightly and loosen the bead -arrow- .

Fig 3: Loosening Plastic Cover
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Disengage plastic cover -1- from the metal clip -2- (-arrow A- ) and detach at the roof frame -3- by pulling it forward -arrow B- .

Fig 4: Removing Plastic Cover
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Open sliding roof cover.
Pull the fabric lining -1- out of the roof profile in -direction of arrow- .

Fig 5: Removing Bottom Connection
Courtesy of PORSCHE CARS NORTH AMERICA, INC.