Tools And Materials

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

The following assembly fixtures must be made for the adjustment operations at the mounting unit.

The following tools and materials are required for making the adjustment devices:
1. 1.1. Sabre saw 00000
2. 1.2. Measuring tape 00000
3. 1.3. Commercially available hardwood block 00000
Make adjustment block for left holder.
1. 2.1. Make hardwood adjustment block -1 L- with the corresponding specified dimensions.
  1. 64 mm
  2. 40 mm
  3. 32 mm
  4. 62 mm
  Fig 1: Identifying Left Holder Adjustment Block Dimensions
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Make adjustment block for right holder.
1. 3.1. Make hardwood adjusting device -1 R- with the corresponding specified dimensions.
  1. 64 mm
  2. 40 mm
  3. 32 mm
  4. 64 mm
  Fig 2: Identifying Right Holder Adjustment Block Dimensions
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.