LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Boxster Spyder >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (60 - Sliding Roof, Tilting Roof -- CARRERA (997)) >> WM 603515 Adjusting Mounting Unit (Drive Mechanism) (911 TARGA 4, 911 TARGA 4S) >> Subsequent Work >> Installing Front Fabric Lining

Installing Front Fabric Lining

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull the connection seal of the fabric lining -1-  into the plastic cover -2-  (-arrow-  ) until the plastic cover -2-  is exposed by only -dimension X= 60 mm-  .
    Fig 1: Pulling Top Connection
    G09824624Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Guide plastic cover -1-  at the front into the roof assembly -2-  (-arrow A-  ) and push in the metal clip -3-  (-arrow B-  ).
    Fig 2: Installing Plastic Cover
    G09824625Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Secure plastic cover -2-  at the rear with the fastening screw.
  4. Pull the fabric lining -1-  forwards -arrow A-  until the plastic cover -2 -  is covered. Lift the plastic cover up slightly and fold over the bead -arrow B-  .
    Fig 3: Securing Top Connection
    G09824626Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals