Assembling Frame For Sliding Roof

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Overview Of Sliding Roof Frame

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Press in fastening nuts -1- on frame for sliding roof -2- .

Fig 2: Pressing Fastening Nut
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit holder for transverse strut -1- on sliding roof frame -2- .

Fig 3: Installing Transverse Strut Holder
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Position seal -1- on frame for sliding roof -2- and press it in until it engages.

Fig 4: Installing Seal
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press the frame clip -1- in on the sliding roof frame -2- until the left and right locking tabs engage.

Fig 5: Pressing Out Frame Clip
Courtesy of PORSCHE CARS NORTH AMERICA, INC.