Mounting Roof Assembly On Assembly Fixture

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Components stored or set down incorrectly

Risk of damage to component surfaces

→ Set the component down on a clean surface, workbench or assembly fixture.

Fig 1: Overview Of Mounting Roof Assembly On Assembly Fixture

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

WE1082 Transmission Jack V.A.G 1383 A
Retaining frame 9695
Support 9695/1
Roof assembly

Get the assembly fixture ready.
1. 1.1. Insert retaining frame 9695 -2- into the → WE1082 transmission jack V.A.G 1383 A -1- .
2. 1.2. Secure holder 9695/1 -3- on the retaining frame 9695 -2- at the positions shown using fastening screws and inlay nuts.
3. 1.3. Holder 9695/1 -3- must then be aligned to the → dimension A: 80 mm and the → dimension B: 975 mm .
  
  Fig 3: Aligning Support To Retaining Frame
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Secure roof assembly to the assembly fixture.
1. 2.1. Position roof assembly -4- on the holder 9695/1 -3- and secure with fastening screws (M8 x 30).
  
  Fig 4: Securing Roof Assembly To Assembly Fixture
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.