Technical Values

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Location	Description	Type	Basic value
Coolant drain plug	Replace sealing ring	Tightening torque	30 Nm (22 ft. lb.)
Spacer to cylinder head 4-6	External Torque screw, M6 x 20	Tightening torque	13 Nm (9.5 ft. lb.)
Transmission bracket to body	M10	Tightening torque	65 Nm (48 ft. lb.)
Transmission support to body	M10	Tightening torque	65 Nm (48 ft. lb.)
Collar nut on engine mount	M12	Tightening torque	85 Nm (63 ft. lb.)
Drive shaft flange to transmission	M10 x 1	Tightening torque	90 Nm (67 ft. lb.)
Lines to B+ box for transmission	M8 hexagon nut	Tightening torque	23 Nm (17 ft. lb.)
Intake air hose to turbocharger	Screw-type clamp	Tightening torque	3 Nm (2 ft. lb.)
Ground strap to body	M8	Tightening torque	23 Nm (17 ft. lb.)
Rear cross member to carrier side section	M12	Tightening torque	110 Nm (81.5 ft. lb.)
Diagonal brace to cross member	M12	Tightening torque	110 Nm (81.5 ft. lb.)
Diagonal brace to carrier side section	M10	Tightening torque	23 Nm (17 ft. lb.)
Diagonal brace to body	M10	Tightening torque	65 Nm (48 ft. lb.)
Transverse strut to body	M10	Tightening torque	65 Nm (48 ft. lb.)
Anti-roll bar to rear axle carrier	M8	Tightening torque	23 Nm (17 ft. lb.)
Anti-roll bar to connecting link	M10	Initial tightening torque	50 Nm (37 ft. lb.)
Anti-roll bar to connecting link	M10	Final tightening torque	65 Nm (48 ft. lb.)
Tailpipe cover to rear silencer	M8	Tightening torque	30 Nm (22 ft. lb.)
Top secondary-air line to cylinder head 1-3	External Torx screw, M6 x 20	Tightening torque	13 Nm (9.5 ft. lb.)
Mounting for air-conditioning compressor	M8	Tightening torque	23 Nm (17 ft. lb.)