Removing Front Roof Trim Panel

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Front Roof Trim Panel Installation Position

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Unscrew fastening screws -1- and remove convertible-top peg mount -2- downwards -Arrow- .

Fig 2: Removing Convertible-Top Peg Mount Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Open up the cap -1- with a screwdriver -Arrow A- .

Fig 3: Removing Mounting Saddle
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew fastening screw -2- and remove mounting saddle -3- (-Arrow B- ).
Unclip wire harness for interior mirror -1- from the holder -Arrow A- and disconnect plug connection -Arrows a- .

Fig 4: Disconnecting Plug Connection For Interior Mirror
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unclip front roof trim panel and remove it by pulling downwards -Arrows- .

Fig 5: Removing Front Roof Trim Panel
Courtesy of PORSCHE CARS NORTH AMERICA, INC.