Installing Cover For Rear Lock Support

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Install cover for rear lock support.
1. 1.1. Position cover for rear lock support -3- and secure with the fastening screws -1- and spring washers -2- . → Tightening torque: 3 Nm (2.0 ft. lb.)
  
  Fig 1: Installing Cover For Rear Lock Support
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw in rubber adjustment stop.
1. 2.1. Screw in rubber adjustment stop -1- at the left and right.
  
  Fig 2: Screwing In Rubber Adjustment Stop
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Adjust rear window cover
1. 3.1. Adjust the height of the rear window cover with respect to the rear center panel by screwing the rubber adjustment stops -1- at the left and right in or out as required. → Gap dimension: 6 mm +/-1 mm → 5000IN DIAGRAM - BODY GAP DIMENSIONS