Installing Clutch
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.
- Insert the centring mandrel 3176
with the drive plate into the guide joint (needle sleeve).
Information
- Clean the friction surfaces of the flywheel and clutch pressure plate prior to installation with brake cleaner or solvent naphtha.
- Surfaces of friction linings must be free from contamination, especially oil and grease.
Information
To avoid deforming the clutch pressure plate, tighten fastening screws in at least 5 steps and in diametrically opposite sequence. Always replace fastening screws.
- Install pressure plate.
Location Description Type Basic value Tolerance 1 Tolerance 2 Clutch pressure plate Initial tightening 15 Nm (11 ftlb.) Clutch pressure plate Torque angle 45° - Remove centring mandrel for toothed segment 9538/1.