Installing Secondary Air Pump

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Position secondary air pump in installation position.
Push on coolant hose -1- .

Fig 1: Identifying Secondary Air Pump Hose
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Connect cable plug and clip it in -1- .

Fig 2: Identifying Secondary Air Pump Cable Plug
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Carefully press cable duct down by hand and screw in and tighten the three Torx screws (M6 x 50) -arrows- . → Tightening torque: 7.5 ftlb. .

Fig 3: Locating Secondary Air Pump Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fasten cable duct by screwing in and tightening the Torx screw (M6 x 16) -arrow- . → Tightening torque: 7.5 ftlb.

Fig 4: Locating Cable Duct Screw
Courtesy of PORSCHE CARS NORTH AMERICA, INC.