Removing Air Conditioning Compressor
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen junction point for terminal 30 line in the engine compartment.
- 1.1. Loosen the two fastening nuts -1- .
- 1.2. Remove junction point for terminal 30 line and the two spacer sleeves -2- and lay them and the connected lines aside.
- Pull off positive crankcase ventilation hose at the oil filler neck.
- 2.1. Release and pull off plug-in coupling -arrow- .
- 2.2. Lay positive crankcase ventilation hose aside.
- Loosen holder for refrigerant lines.
- 3.1. Screw off fastening nut -1- .
- 3.2. Open the holder -2- and remove the rubber sleeve -3- .
- Disconnect plug connection for air conditioning compressor.
- 4.1. Release -arrow A- and pull off -arrow B- connector.
- 4.2. Pull plug-in coupling out of the holder -arrow C- .
- Loosen air conditioning compressor.
- 5.1. Unscrew the three fastening screws -1- .
- 5.2. Remove the holder -2- (-arrow-) .
- Remove air conditioning compressor.
- 6.1. Carefully pull the air conditioning compressor forward in -direction of arrow- until the refrigerant lines are easily accessible.
- 6.2. Unscrew the fastening screws -1- , pull out the refrigerant lines and close them off immediately using suitable stoppers.
- 6.3. Remove air conditioning compressor in -direction of arrow- .