LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Boxster Spyder >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (10 - Engine - Crankcase, Suspension -- 987-BOXSTER-CAYMAN) >> WM 103219 Removing And Installing Engine Carrier (Except CAYMAN Black Edition, CAYMAN S Black Edition, BOXSTER Black Edition, BOXSTER SPYDER, BOXSTER S "PORSCHE Design Edition 2", BOXSTER S Black Edition, CAYMAN R) >> Subsequent work

Subsequent work

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Information 

  1. Install two coolant hoses (supply and return line).
    1. 1.1. Coat O-rings with Kluberplus gel.
    2. 1.2. Clip in spring clamps.
    3. 1.3. Fit Henn couplings to the coolant pipes (listen for audible click) and check they are seated securely.
  2. Fill in coolant and bleed cooling system. Remove engine compartment cover to do this.

    → Filling Coolant .

  3. Start the engine and inspect the coolant hoses for leaks.
  4. Install engine compartment lid.

    → Installing engine compartment lid .

  5. Install rear wall cover.

    → 555919 REMOVING AND INSTALLING REAR WALL COVER .

  6. Install rear and center underbody covers.

    → Installing cover for rear underbody .

    → Installing cover for center underbody .

  7. Remove protective covers.
  8. Move seats into initial position.
scientia non olet · About LEMON Manuals