Instructions For Assembling Transmission Cover

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Overview Of Transmission Cover

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fill the shaft seal -14- between the dust and sealing lips with multipurpose grease and drive in with a suitable tubular piece (e.g. vw 423 ). Observe the correct drive-in depth -a = 1 mm- .

Fig 2: Tapping Sealing Ring
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Information
- The needle-roller bearing and plastic sleeve must always be replaced.
Press in bushing -13- as far as the stop with pressure pieces (4) 9247/1 and pull-in tool and puller p 254 .
Press needle-roller bearing and plastic sleeve -12- into correct position using auxiliary piece vw 295 a and a suitable tubular piece (e.g. vw 420 ). The large collar of the auxiliary piece vw 295 a is facing the needle-roller bearing. Observe the correct drive-in depth -a = 216- .

Fig 3: Identifying Needle-Roller Bearing Drive-In Depth
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press in outer bearing ring -8- with a pressure piece 3005 and a suitable extension.

Fig 4: Pressing In Outer Bearing Ring
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit transmission cover -16- . To do this, coat cover sealing surfaces lightly with Loctite 574 and screw in Torx screws.

Location	Description	Type	Basic value	Tolerance 1	Tolerance 2
Torx screw		Tightening torque	25 Nm (19 ftlb.)