LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Boxster Spyder >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (34 - Mechanical Gear-Shift System - Actuation, Housing -- 987-BOXSTER-CAYMAN) >> WM 343519 Removing And Installing Transmission (CAYMAN, BOXSTER, BOXSTER LIM. Ed. "Orange", BOXSTER "Sport Edition") >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.
  1. Retaining device 9624/3  must be removed from the cross member.
    Fig 1: Identifying Retaining Device
    G09586587Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Fit restraining cables to cross member.
    Location Description Type Basic value Tolerance 1 Tolerance 2
    Restraining cable Fastening nut between restraining cable and cross member Tightening torque 23 Nm (17 ftlb.)    
  3. Install support plate.

    → INSTALLING SUPPORT PLATE

  4. Install rear silencer.

    → INSTALLATION

  5. Adjust the shift and selector cables. → Installing Shift And Selector Cables 341219 REMOVING AND INSTALLING SHIFT AND SELECTOR CABLES 
  6. Mount wheels.

    → INSTALLING FRONT WHEEL HOUSING LINER

  7. Check and if necessary top up transmission oil.

    → 340135 CHECKING AND TOPPING UP TRANSMISSION OIL 

  8. Lower the vehicle.
scientia non olet · About LEMON Manuals