Assembly Work

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Engage shift cable (with grey sealing cap) -1- and selector cable (with blue sealing cap) -2- in the support and press on the ball pin.

Fig 1: Engaging Shift And Selector Cables
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Push on electric connector for back-up light switch.

Fig 2: Identifying Back-Up Light Switch
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fit drive shafts on the transmission side. For this purpose, tighten six hexagon socket screws between the drive shaft and the transmission flange, respectively. Counter on the brake disc or activate the parking brake to avoid simultaneous turning.

Fig 3: Identifying Drive Shaft

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Location	Description	Type	Basic value	Tolerance 1	Tolerance 2
Drive shafts	Fastening screws between drive shaft and transmission flange	Tightening torque	81 Nm (60 ftlb.)

Screw in fastening screws between anti-roll bar and rear axle carrier side member.

Fig 4: Locating Anti-Roll Bar

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Location	Description	Type	Basic value	Tolerance 1	Tolerance 2
Anti-roll bar	Fastening screws between anti-roll bar and rear axle carrier side member	Tightening torque	23 Nm (17 ftlb.)