Removing Gearshift Bracket

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Locking bridge 9619/1 must be fitted on the gearshift bracket.

Fig 1: Fitting Locking Bridge
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Open bayonet locks on the pre-selector and shifting connections.

Fig 2: Opening Bayonet Lock
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Disengage adjustment pin on pre-selector and shifting connections.

Fig 3: Disengaging Shift Cables
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unclip supports on the gearshift bracket.

Fig 4: Removing Gearshift Bracket Supports
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Unscrew nut and lift gearshift bracket up and off.

Fig 5: Removing Gearshift Bracket
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove locking bridge.

Fig 6: Removing Locking Bridge
Courtesy of PORSCHE CARS NORTH AMERICA, INC.