LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Boxster Spyder >> Repair and Diagnosis >> External Pages >> Different car >> Section 111 (13 - Engine - CRANKGEAR, Pistons -- 987-BOXSTER-CAYMAN) >> WM 136019 Removing And Installing Flywheel >> Installing Dual-Mass Flywheel >> Installing Double-Mass Flywheel

Installing Double-Mass Flywheel

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Information 

Before re-installing the flywheel, clean the friction surface of the flywheel using a clean, lint-free cloth soaked in acetone or solvent naphtha).

  1. Position double-mass flywheel on the crankshaft's dowel pin and press on to the crankshaft flange. Insert all fastening screws (8).
  2. Align toothed segment 9538/1  and tighten fastening screw again.
  3. Screw in and tighten fastening screws in diagonally opposite sequence. → Initial tightening: 19 ftlb.  ; → Final tightening - torque angle: 120° 
  4. Remove toothed segment.
scientia non olet · About LEMON Manuals