Removing DME Control Unit

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Installation Position Of DME Control Unit

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

NOTE: Voltage peaks

Risk of damage to load or to the control unit

→ Remove the ignition key and switch off load before disconnecting or removing load.

Remove DME control unit.
1. 1.1. Screw off the three fastening nuts -1- on the DME control unit.
2. 1.2. Place DME control unit in the luggage compartment.
  
  Fig 2: Removing DME Control Unit
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Pull off connectors on the DME control unit.
1. 2.1. Release -arrows A- and pull off -arrows B- the five connectors.
2. 2.2. Remove DME control unit.
Fig 3: Pulling Off Connectors On DME Control Unit
Courtesy of PORSCHE CARS NORTH AMERICA, INC.