Installing Coolant Regulator Cover

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Information

Grease O-rings, hoses and lines in the cooling system with Kluberplus Gel (Part No. 000.043.205.93) .

Install new profile seal -3- .

Fig 1: Identifying Coolant Regulator
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install coolant regulator cover.
1. 2.1. Fit coolant regulator cover with top screw inserted in installation position.
2. 2.2. Fit the two bottom external Torx screws (E10, M6 x 50) -1- and tighten slightly.
3. 2.3. Fit and tighten the top external Torx screw (E10, M6 x 50) -1- from inside the passenger compartment. Insert for torque wrench 9792 can be used for this.
4. 2.4. Tighten the bottom external Torx screws (E10, M6 x 50) -1- on the coolant regulator cover.
  → Tightening torque: 13 Nm (9.5 ftlb.)
Fig 2: Identifying Coolant Regulator Housing
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Use external Torx screw (E10, M6 x 12) -3- to secure the coolant pipe to the coolant regulator housing and crankcase.
→ Tightening torque: 13 Nm (9.5 ftlb.)

Fig 3: Identifying Coolant Pump
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit coolant hose on coolant regulator housing.
1. 4.1. Check that the spring clamp is fitted correctly and the coolant hose is engaged correctly.