Installing Bracket For Oil Cooler

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Information

Always replace gaskets and O-rings.

Grease all gaskets (except for the cooling system) with Kluber Syntheso Glep (Part No. 000.043.204.68).

Replace stoppers at the connection points and fit new O-rings -1- and profile seal -2- .

Fig 1: Identifying Seals On Oil Cooler Bracket
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install bracket for oil cooler from above.
Fit screws and tighten uniformly. → Tightening torque: 13 Nm (9.5 ftlb.)
1. 3.1. Fit external Torx screws (M6 x 45). -1-
  
  Fig 2: Identifying Screws On Bracket For Oil Cooler (1)
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. 3.2. Fit external Torx screws (M6 x 60) -1- and -1- .
  
  Fig 3: Identifying Screws On Bracket For Oil Cooler (2)
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  
  Fig 4: Identifying Screws On Bracket For Oil Cooler (3)
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Secure cable with the cable clip -1- . → Tightening torque: 3 Nm (2 ftlb.)

Fig 5: Identifying Cable Clip On Oil-Filter Housing
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Connect cable plug -1- on oil pressure sensor.

Fig 6: Identifying Cable Plug On Oil Pressure Sensor
Courtesy of PORSCHE CARS NORTH AMERICA, INC.