Installing Generator

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.

Connect electric plug connections.
1. 1.1. Fit the generator.
2. 1.2. Position terminal 30 line and tighten fastening nut -1- . → Tightening torque: 18 Nm (13 ftlb.)
3. 1.3. Close cover on terminal 30 line -arrow A- .
4. 1.4. Clip in line on the generator using the retaining clip -arrow B- .
5. 1.5. Plug in the connector -arrow C- until it engages securely.
Fig 1: Connecting Electric Plug Connections
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Install the generator.
1. 2.1. Fit the generator -arrow A- and place it above the holder in installation position -arrow B- .
2. 2.2. Tighten fastening screws -1- . → Tightening torque: 23 Nm (17 ftlb.)
Fig 2: Installing Generator
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Secure the fuel line.
1. 3.1. Using the rubber sleeves -1- , carefully press the fuel line into the two brackets -arrows- .
Fig 3: Pressing Fuel Line Into Brackets
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Secure the power-steering pump pulley with three fastening screws.
Raise and secure the engine.
1. 5.1. Carefully raise the engine using the jack.
2. 5.2. Screw on the four fastening nuts -2- on the engine mounting -1- . → Tightening torque: 65 Nm (48 ftlb.)
3. 5.3. Move the jack out of the work area.
  
  Fig 4: Identifying Engine Mounting And Fastening Nuts
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.