LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Boxster Spyder >> Repair and Diagnosis >> Collision >> Body Panels >> 53 - Body Rear - BOXSTER & CAYMAN (981) >> WM 534855 REPLACING REAR SIDE MEMBER (Except Boxster GTS) >> Subsequent Work >> Subsequent Work For Body Repairs

Subsequent Work For Body Repairs

  1. Release and remove vehicle from the straightening system.
  2. Clean joint areas and sheetmetal flanges with a wire brush.
  3. Prime joint areas and sheetmetal flanges with 2K primer.
  4. Restore standard seal with body sealant → 5X00IN42 SEAM SEALING .

    Also seal the repair area carefully.

  5. Paint repair area and adjacent surfaces, if necessary.
  6. Restore standard underbody protection with underbody sealant → 5X00IN43 UNDERBODY PROTECTION .
  7. Apply standard cavity preservation → 5X00IN44 CAVITY PRESERVATION . Also carefully apply cavity preservation to the repair area.
  8. Install removed accessories in the repair area.
scientia non olet · About LEMON Manuals