Installing Roofliner

Installation is performed in reverse order to removal.

1. Secure tension rope.
   1. 1.1. Insert tension rope -1-  into the molded piece -2-  . The ball must be outside of the molded piece.
   2. 1.2. Carefully guide the molded piece -2-  with the tension rope into the control arm.
   3. 1.3. Clip the molded piece into the control arm. -arrow A- 
   4. 1.4. Clip the ball into the molded piece by pulling on the tension rope -1-  . -arrow B- 

      Tightening torque 2.8 Nm (2 ftlb.) 

      Tightening torque 6.0 Nm (4.5 ftlb.) 

      Tightening torque 3.5 Nm (2.5 ftlb.) 

   Fig 1: Securing Tension Rope

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.