General Information

Information 

• Apply sparingly since the volume of the foam filler will expand by approx. 50-100% in open areas and by approx. 100-200% in cavities. Approx. 0.25 liters of foam volume is produced per second of foam time (free-foaming). 
• The foam filler is silver-grey. 
• Remove fresh foam residues immediately using PU cleaner. Hardened foam residues can only be removed mechanically afterwards. 
• Always remove foam from the can following activation. 

Information 

• In addition to this Service Information, observe the relevant job descriptions for body repairs! 

Information 

• The vehicle, components and adhesives must be brought to processing temperature (acclimatised) before getting started. The processing temperature must be maintained for 30 minutes before starting to work on the bonding surfaces. 
• Bonding surfaces must be free of oil, dirt, moisture and paint and oxide coatings. 
• Do not touch the cleaned surfaces in order to avoid transferring sweat from your hands or dirt to the bonding surfaces. 

Information 

• Process the adhesive within the processing time. The adhesive must be applied and the body part must be joined within this time period. Any resistance welding or mechanical joining procedures (e.g. riveting, screwing) to be carried out in the bonding area must also be performed within this time period. 
• Do not put pressure on bonded parts until hardening is complete! 

Information 

During cold periods, overnight or in cold countries, appropriate steps must be taken to ensure that the minimum hardening temperature is reached.

• Optimise heating system settings, e.g. deactivate night-time lowering of temperature. 
• Keep doors and windows closed; avoid draughts. 
• Install auxiliary heaters in the body repair area.