Installing High Beam Halogen Bulb

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Incorrect handling of bulbs

Risk of damage to bulbs and the bulb housing

→ Switch off ignition and remove ignition key.

→ Switch off the relevant loads when changing bulbs.

→ Only use bulbs listed in the bulb table.

→ Only install clean bulbs that are free of grease.

→ Always use a cloth or soft paper when working with bulbs.

→ Observe the safety instructions when changing a bulb in a Bi-Xenon headlight.

→ In certain states, it is compulsory to carry spare light bulbs.

Replace faulty lamp. Ensure that the lamp is seated correctly when doing so.
Engage retaining bow -3- .

Fig 1: Engaging Retaining Bow
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Connect electric connector -2- . Check that it is seated securely.

Fig 2: Plugging In Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit the side lid -1- and close it (observe markings indicating direction to turn).

Fig 3: Closing Lid
Courtesy of PORSCHE CARS NORTH AMERICA, INC.