LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Boxster S, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 287 (34 Mechanical Transmission Actuator Housing -- 911 CARRERA (991)) >> WM 343519 Removing And Installing Transmission (Except CARRERA "Edition", CARRERA Cabriolet "Edition", Turbo, Turbo S, CARRERA 4 "Edition", Turbo CABRIO, Turbo S CABRIO, CARRERA 4 Cabriolet "Edition", Gt3, Gt3 RS) >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check transmission oil and top up if necessary.

    → Topping Up Transmission Oil  .

  2. Carry out a function test on the shift and selector cables.

    → Removing Shift And Selector Cables .

  3. Fit rear underbody panelling.

    → INSTALLING COVER FOR REAR UNDERBODY .

    Additional work for all-wheel drive vehicles: 

  4. Install cardan shaft.

    → INSTALLING CARDAN SHAFT .

  5. Install cover for center underbody.

    → INSTALLING COVER FOR CENTRE UNDERBODY .

    All vehicles: 

  6. Check the coolant level and top up if necessary.

    → 193817 DRAINING AND FILLING COOLANT .

  7. Bleed the cooling system.

    → 190107 BLEEDING THE COOLING SYSTEM .

  8. Connect the battery.

    → 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY .

scientia non olet · About LEMON Manuals