Installing Sun Blind

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

If the electric drive for the sun blind was removed, make sure that the sun blind carriers at the left and right are parallel to each other. The sun blind coupling must be moved out of the guide rail.

Insert sun blind carrier -1- into the sun blind coupling -4- from above.

Fig 1: Inserting Sun Blind Carrier
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Slide sun blind carrier -1- into the guide rail -2- .

Fig 2: Identifying Sun Blind Carrier And Guide Rail
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Engage fabric centering device -1- at the retaining clip for the guide tube -2- .

Fig 3: Installing Fabric Centering Device
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Move sun blind motor to the Close position manually -B- .

Fig 4: Positioning Sun Blind Manually
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Position sun blind well -2- and secure with a fastening screw -1- .

Fig 5: Positioning Sun Blind Well
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Position transverse bow and secure with a fastening screw -1- .

Fig 6: Securing Fastening Screw Of Transverse Bow
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fastening screw for transverse bow. Tightening torque 2.5 Nm (2 ft. lbs.)