Bumper, Rear Apron

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Location	Description	Type	Basic value	Tolerance 1
Fastening screws for bumper reinforcement	Item 1	Tightening torque	23 Nm (17 ftlb.)	+/-2 Nm (+/- 1.5 ftlb.)
Removing rear bumper
Fastening screws on heat protection		Tightening torque	3 Nm (2 ftlb.)
Loosening heat protection at the sides
Fastening screws for rear apron, bottom		Tightening torque	3.2 Nm (2 ftlb.)	+/-0.6 Nm (+/- 0.5 ftlb.)
Loosening rear apron at the sides
Fastening screws for rear apron, top		Tightening torque	3.2 Nm (2 ftlb.)	+/-0.6 Nm (+/- 0.5 ftlb.)
Removing spoiler cover (tail light)
Fastening screw 3		Tightening torque	7 Nm (5 ftlb.)	+/-0.7 Nm (+/- 0.5 ftlb.)
Unscrewing screw
Fastening nut for trim on rear apron	Item 2	Tightening torque	2.5 Nm (2 ftlb.)
Removing trim for rear apron, top
Fastening screw for trim on rear apron	Item 1	Tightening torque	2.5 Nm (2 ftlb.)
Removing side trim for rear apron
Fastening screw securing tailpipe shield cover to rear skirt		Tightening torque	2.5 Nm (2 ftlb.)
Removing tailpipe shield cover