Component And Assembly Overview
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| No. | Designation | Qty. | Removal | Installation |
|---|---|---|---|---|
| -1- | Hexagon nut M14 x 1.5 | 1 | Before loosening the hexagon nut, pretension the coil spring with the spring tensioner. Loosen hexagon nut using Porsche special tool: socket-wrench insert 9630/2 or VW special tool: socket-wrench insert 3186 . Counter at the piston rod while loosening (and tightening). |
Use a new hexagon nut. Tightening torque 70 Nm (52 ftlb.) |
| -2- | Spring-strut mount | 1 | Identical parts on the left and right side | |
| -3- | Ball bearing | 1 | Replace if necessary. | |
| -4- | Tolerance compensation shim | 1 | Not always present. Observe allocation according to coil spring tolerance group (load group). This is described in the Assembly section (Information). |
|
| -5- | Spring plate, upper | 1 | Replace if necessary. | |
| -6- | Coil spring | 1 | Only available as a set. Observe allocation as per Spare Parts Catalogue. | |
| -7- | Bellows | 1 | Replace if necessary. | |
| -8- | Additional spring | 1 | Before installation, assemble at the correct position with No. -7- . | |
| -9- | Stop washer | 1 | Replace if necessary. | |
| -10- | Spring plate, lower | 1 | Replace if necessary. | |
| -11- | Vibration damper | 1 | Identical parts on the left and right side. Observe allocation as per Spare Parts Catalogue. | |
| -12- | Hexagon-head bolt, M10 x 55 | 1 | Only on vehicles with PDCC. | Tightening torque 46 Nm (34 ftlb.) |
| -13- | PDCC holder | 1 | Only on vehicles with PDCC. | Fit at the correct position on lower concave washer. |