Installing Oil/Water Heat Exchanger

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Fit new sealing rings.
Install oil/water heat exchanger -1- .
1. 2.1. Position oil/water heat exchanger on the bracket.
  Check that the sealing rings are at the correct position!
2. 2.2. Fit and tighten six screws -2- . Tightening torque 10 Nm (7.5 ftlb.)
3. 2.3. Connect cable plug for oil pressure sender and clip in electric line.
  
  Fig 1: Identifying Heat Exchanger Threaded Joint
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.