Installing Light Bulb For Reversing Light

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

If the tail light is opened, the seals for the central connector and cover must be replaced.

The left tail light is described here.

Fit a new rubber seal -7- all the way around on the cover of the tail light.

Fig 1: Fitting Rubber Seal In Cover
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Stick on a new seal around the central connector -6- on the tail light.

Fig 2: Sticking On Seal For Central Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit light bulb -5- into the tail light.

Fig 3: Fitting And Screwing In Light Bulb And Connecting Connector
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Screw in the two fastening screws -4- for the light bulb. → Tightening torque: 2.5 Nm (2 ftlb.)
Connect the two electric connectors -2- and -3- to the light bulb and check that they are seated securely.
Fit tail light cover and secure with the seven fastening screws -1- .

Fig 4: Identifying Cover And Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.