LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Boxster GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 154 (40 - Front Wheel Suspension, Drive Shafts -- CARRERA (997)) >> WM 405055 Replacing Front Wheel Bearing Housing (Except Gt3, Gt2, Gt3 RS, Gt2 RS, Gt3 RS 4.0) >> Replacing Front Wheel Bearing Housing - Subsequent Work

Replacing Front Wheel Bearing Housing - Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fit front wheel → 440519 REMOVING AND INSTALLING WHEEL .
  2. Tighten the central nut at the wheel carrier or, with the 911 Carrera 4/911 Turbo, the drive shaft fastening at the side of the wheel to 460 Nm (340 ftlb.). Actuate the brake while doing this.
  3. Check wheel alignment values on front axle and adjust if necessary → 449503 PERFORMING FRONT AND REAR SUSPENSION ALIGNMENT .
scientia non olet · About LEMON Manuals