Fitting Drive Shaft
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2012 Porsche Cayman, 2012 Porsche Boxster, 2011 Porsche Cayman, 2011 Porsche Boxster, and 2010 Porsche Cayman. However, it is still accessible from the selected car via links, so may be relevant.
| No. | Designation | Qty. | Fitting |
|---|---|---|---|
| -1- | Circlip | 1 | Calculate thickness of circlip again if the drive shaft and fixed gear wheel for 5th gear are replaced. |
| -2- | Fixed gear wheel, 5th gear | 1 | Heat to approx. 100 °C and press on in the correct position. |
| -3- | Needle-roller bearing | 1 | Fit with loose gear wheel for 4th gear -4- . |
| -4- | Loose gear wheel, 4th gear | 1 | Insert spring before assembly. |
| -5- | Synchronizer ring, 4th gear | 1 | Check for wear and fit with loose gear wheel for 4th gear -4- . |
| -6- | Operating sleeve | 1 | Observe installation position; fit operating sleeve so that the slant is facing 4th gear and the offset side is facing 3rd gear. |
| -7- | Blue circlip | 1 | Calculate thickness of circlip again if the drive shaft and synchronizing hub -8- are replaced. |
| -8- | Synchronizing hub | 1 | Heat to approx. 100 °C and press on (high collar facing loose gear wheel for 3rd gear). |
| -9- | Synchronizer ring, 3rd gear | 1 | Check for wear and fit with loose gear wheel for 3th gear -10- . |
| -10- | Loose gear wheel, 3rd gear | 1 | Insert spring before assembly. |
| -11- | Brown circlip | 1 | Always use the same thickness! |
| -12- | Needle-roller bearing | 1 | Fit with loose gear wheel for 3rd gear. |
| -13- | Drive shaft | 1 | If the drive shaft and ball bearing -15-
are replaced, the circlips -14-
and -16-
must be measured again. → 354015 ADJUSTING THE DRIVE SHAFT |
| -14- | Circlip | 1 | Calculate the thickness again if necessary. → 354015 ADJUSTING THE DRIVE SHAFT |
| -15- | Ball bearing | 1 | → ASSEMBLING TRANSMISSION |
| -16- | Circlip | 1 | Calculate the thickness again if necessary. → 354015 ADJUSTING THE DRIVE SHAFT |
| -17- | Needle-roller bearing | 1 | → ASSEMBLING TRANSMISSION |
| -18- | Transmission housing | 1 | |
| -19- | Needle-roller bearing | 1 | → ASSEMBLING TRANSMISSION COVER |
| -20- | Plastic sleeve | 1 | |
| -21- | Transmission cover | 1 | → ASSEMBLING TRANSMISSION COVER |