LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Boxster GTS, Standard Trans >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> 42 - Rear Wheel Suspension, Drive Shafts -- (981) BOXSTER/CAYMAN >> WM 421119 Removing And Installing Rear Trailing Arm (CAYMAN "Black/Style Edition", BOXSTER "Black/Style Edition", CAYMAN Gt4) >> Removing And Installing Rear Trailing Arm >> Removing Rear Trailing Arm

Removing Rear Trailing Arm

  1. Remove brake air spoiler.
    Fig 1: Removing Brake Air Spoiler Mounting
    G10023538Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    1. 1.1. Unscrew fastening screws -1-  .
    2. 1.2. Move brake air spoiler in direction of travel -arrow A-  and remove it by pulling it downwards -arrow B-  .
  2. Loosen level sensor linkage -1-  from the holder on the trailing arm -2-  .
    Fig 2: Loosening Level Sensor Linkage
    G10023539Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    1. 2.1. Screw off fastening nut and counter at the square part of the ball joint while doing this.
    2. 2.2. Pull linkage out of the holder.
  3. Remove trailing arm -1-  .
    Fig 3: Identifying Trailing Arm Mounting
    G10023540Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    1. 3.1. Mark the position of the camber eccentric adjuster -2-  on the rear-axle carrier side section.
    2. 3.2. Loosen threaded connections -2 to 4-  .
scientia non olet · About LEMON Manuals