LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Boxster GTS, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 293 (66 - Exterior Equipment -- 911 CARRERA (991)) >> WM 665619 Removing And Installing Ventilation Grille For Lid (Rear) (Gt3 RS) >> Installing Ventilation Grille For Lid (Rear)

Installing Ventilation Grille For Lid (Rear)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in reverse order. Pay particular attention to the following: 

  1. Tighten fastening screws on underside of rear lid Item 1  to the specified torque. Tightening torque 5.6 Nm (4.5 ftlb.) 
  2. Tighten fastening screws on underside of rear lid Item 2  to the specified torque. Tightening torque 4 Nm (3 ftlb.) 
  3. Tighten fastening screws between the grille and retaining frame to the specified torque. Tightening torque 5.6 Nm (4.5 ftlb.) 
scientia non olet · About LEMON Manuals