LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Boxster GTS, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 284 (37 Automatic Transmission - Actuator, Housing -- 911 CARRERA (991)) >> WM 371319 Removing And Installing Locking Cable (Except CARRERA "Edition", CARRERA Cabriolet "Edition", CARRERA 4 "Edition", CARRERA 4 Cabriolet "Edition") >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install selector support. → 370819 REMOVING AND INSTALLING SELECTOR SUPPORT 
  2. Install centre console. → 681719 REMOVE AND INSTALL CENTRE CONSOLE
  3. Move selector lever from position "P" to "D" and from position "D" to "M" and back again several times.
  4. Check that the parking lock is disengaged.
    1. 4.1. Insert ignition key into the ignition lock.
    2. 4.2. Move selector lever to position "P". "P" appears in the instrument cluster.
    3. 4.3. Actuate the operating brake.
    4. 4.4. Start the engine.
    5. 4.5. Move selector lever to position "D". "D" appears in the instrument cluster.
    6. 4.6. Release the operating brake. If the vehicle moves forward, the test is complete. Otherwise, all connecting pieces must be checked again.
  5. Check that the parking lock is engaged (engine running).
    1. 5.1. Insert ignition key into the ignition lock.
    2. 5.2. Move selector lever to position "P". "P" appears in the instrument cluster.
    3. 5.3. Actuate the operating brake.
    4. 5.4. Start the engine.
    5. 5.5. Release the operating brake. The vehicle must not move. Otherwise, the entire system must be checked.
    6. 5.6. Switch off engine.
  6. Check that the parking lock is engaged (blocking effect).
    1. 6.1. Insert ignition key into the ignition lock.
    2. 6.2. Move selector lever to position "P". "P" appears in the instrument cluster.
    3. 6.3. Move selector lever to position "N". "N" appears in the instrument cluster.
    4. 6.4. Get another person to help you to push the vehicle for a distance of at least one meter. It must be possible to move the vehicle. Otherwise, the entire system must be checked.
    5. 6.5. Actuate the operating brake.
    6. 6.6. Move selector lever to position "P". "P" appears in the instrument cluster.
    7. 6.7. Get another person to help you to push the vehicle. The vehicle must not move (a max. movement of 150 mm is acceptable). Otherwise, the entire system must be checked.
scientia non olet · About LEMON Manuals