Corresponds To 1 Click On The Adjustment Device

Information 

A calculated value in the positive range means: Turn adjustment device towards A - loosen.

A calculated value in the negative range means: Turn adjustment device towards B - tighten.

Adjustment dimension = required dimension - actual dimension  (required dimension minus actual dimension)

Example:

Actual dimension: 2.6 mm

Required dimension: 2.0 mm (+/- 0.3 mm)

Adjustment dimension = required dimension - actual dimension

Adjustment dimension = 2.0 mm - 2.6 mm

Adjustment dimension = -0.6 mm

-0.6 mm: 0.15 mm = - 4 clicks (0.15 mm corresponds to one click!)

Adjustment dimension = -0.6 mm: This means that the gap dimension is too big and the adjustment device must be adjusted towards B - tighten.

Information 

• Grinding down applies only to grey cast-iron brakes with one-piece brake discs  .
• Grinding of grey cast-iron brakes on the Cayman GT4 (981) is not permitted because compound brake discs with aluminum brake disc hubs are installed  .
• Grinding of PCCB brake discs/brake shoes is not permitted  .
• Grinding must be performed after setting the brake shoes to the basic setting  .
• The brake shoes must be ground down prior to calibration  .
• It is not necessary to grind down the parking-brake shoes when you are removing/installing the brake discs and/or parking-brake shoes  .

1. 6. Grind down parking-brake shoes →  468350 GRINDING DOWN PARKING-BRAKE SHOES   .
2. 7. Calibrate the EPB using PIWIS Tester II. To do this, select >>Parking brake<< in the control unit overview. Select >>Maintenance/repairs<< >>Calibration<<.
3. 8. To check the function of the EPB, actuate the EPB button several times (press 2-3 times) and make sure that the actuators open and close on both sides.

   Position disc brake pads by operating the brake several times.

4. 9. Fit wheels → Installing Wheel .