LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Boxster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (42 Rear Wheel Suspension, Drive Shaft -- 911 CARRERA (991)) >> WM 429019 Removing And Installing Rear Anti-Roll Bar (Gt3, Gt3 RS) >> Removing And Installing Rear Anti-Roll Bar >> Installing Rear Anti-Roll Bar

Installing Rear Anti-Roll Bar

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install anti-roll bar -1-  .
    1. 1.1. Screw in M8 fastening screws for anti-roll bar clamps -4-  .

      Tightening torque 25 Nm (19 ftlb.) 

    2. 1.2. Fit connecting links (suspension/stabilizer) in the central position on the anti-roll bar -arrow-  .

      Use new collar nuts -2-. 

      Initial tightening 40 Nm (30 ftlb.) Final tightening +30°  .

      Fig 1: Identifying Anti-Roll Bar Mount
      G09993059Courtesy of PORSCHE CARS NORTH AMERICA, INC.
      Fig 2: Locating Suspension/Stabilizer On Anti-Roll Bar Position
      G09993060Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals