LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Boxster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (42 Rear Wheel Suspension, Drive Shaft -- 911 CARRERA (991)) >> WM 422119 Removing And Installing Rear Drive Shaft (Except CARRERA "Edition", CARRERA Cabriolet "Edition", CARRERA 4 "Edition", CARRERA 4 Cabriolet "Edition", Gt3, Gt3 RS) >> Removing And Installing Drive Shaft >> Installing Drive Shaft

Installing Drive Shaft

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Always replace lock nuts and screws using the torque angle tightening procedure.

Observe specified tightening torques. → 4X00IN TIGHTENING TORQUES FOR REAR AXLE .

  1. Installation is performed in reverse order.

    Check the following before installation:

    Check inner/outer bellows and replace if necessary.

    → 422855 REPLACING DRIVE SHAFT BELLOWS .

    Grease the drive shaft toothing with Optimoly HT.

scientia non olet · About LEMON Manuals