Technical Values
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Anti-roll bar clamp to mounting | M8 hexagon nut | Tightening torque | 25 Nm (19 ftlb.) | ||
| Connecting link (suspension/stabilizer) to anti-roll bar | Collar nut, M10/always use new collar nut following removal | Initial tightening | 40 Nm (30 ftlb.) | ||
| Connecting link (suspension/stabilizer) to anti-roll bar | Collar nut, M10/always use new collar nut following removal | Final tightening | +30° | ||
| No. 2/Diagonal brace (No. 1) to rear-axle cross member | M12 x 1.5 x 45/always use new screws following removal | Initial tightening | 30 Nm (22 ftlb.) | ||
| No. 2/Diagonal brace (No. 1) to rear-axle cross member | M12 x 1.5 x 45/always use new screws following removal | Final tightening | +90° | ||
| No. 3/Diagonal brace (No. 1) to body front | M12 x 1.5 x 40/always use new screws following removal | Initial tightening | 90 Nm (67 ftlb.) | ||
| No. 3/Diagonal brace (No. 1) to body front | M12 x 1.5 x 40/always use new screws following removal | Final tightening | +90° | ||
| No. 4/Diagonal brace (No. 1) to mounting for longitudinal arm (diagonal arm)/911 GT3 | Cheese head bolt, M8 x 30 | Tightening torque | 23 Nm (17 ftlb.) |