Installing Rear Anti-Roll Bar

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Install anti-roll bar -1- .
1. 1.1. Screw in M8 fastening screws for anti-roll bar clamps -4- .
  Tightening torque 25 Nm (19 ftlb.)
2. 1.2. Fit connecting links (suspension/stabilizer) in the central position on the anti-roll bar -arrow- .
  Use new collar nuts -2-.
  
  Initial tightening 40 Nm (30 ftlb.) Final tightening +30° .
  
  Fig 1: Identifying Anti-Roll Bar Mount
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  
  Fig 2: Locating Suspension/Stabilizer On Anti-Roll Bar Position
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.