Installing Rear Tie Rod (Toe Control Arm)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- Fit toe control arm -2-
on the rear-axle carrier side section -1-
.
Fit eccentric washer -4- at the position marked (prior to removal).
Tighten lock nut -5- to Tightening torque 100 Nm (74 ftlb.) .
- Install rear-axle carrier side section.
Use a new lock nut and hexagon-head bolts. Observe the specified tightening torques/torque angles!
Lock nut Initial tightening 90 Nm (67 ftlb.) Final tightening +90°
Hexagon-head bolts Initial tightening 90 Nm (67 ftlb.) Final tightening +90°