LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Boxster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (42 Rear Wheel Suspension, Drive Shaft -- 911 CARRERA (991)) >> WM 420619 Removing And Installing Rear-Axle Cross Member (Except CARRERA "Edition", CARRERA Cabriolet "Edition", CARRERA 4 "Edition", CARRERA 4 Cabriolet "Edition", Gt3, Gt3 RS) >> Preliminary Work

Preliminary Work

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information 

If the rear-axle cross member only has to be lowered, refer to the following document. → 420609 LOOSENING AND SECURING REAR-AXLE CROSS MEMBER 

  1. Raise the vehicle.

    → 4X00IN LIFTING THE VEHICLE .

  2. Remove wheels on rear axle.

    → 440519 REMOVING AND INSTALLING WHEEL .

  3. Remove cover for rear underbody.

    → 519419 REMOVING AND INSTALLING COVER FOR REAR UNDERBODY .

scientia non olet · About LEMON Manuals